Modern LED Wall Lamp with Motion Sensor – Up & Down Outdoor Light for Stairs, Hallway & Porch

Installation Type: Outdoor Wall Mount (Hardwired)

1. Turn off the circuit breaker controlling the outdoor electrical circuit before beginning installation.

2. Position the mounting bracket on the exterior wall at your desired height and mark the screw holes. For motion sensor variants, mount at 6–8 feet high for optimal detection coverage.

3. Drill holes at marked positions. Use masonry anchors for brick, stone, or concrete walls; standard wall plugs for wood or composite siding.

4. Secure the mounting bracket to the wall with the provided stainless-steel screws.

5. Connect the fixture wires to your outdoor-rated supply wires — live to live, neutral to neutral, ground to ground. Use waterproof wire connectors for all outdoor connections.

6. Attach the lamp body to the bracket and tighten the securing screws. Ensure all gaskets and seals are properly seated to maintain the IP66 waterproof rating.

7. Restore power and test the light. For motion sensor variants, walk through the detection zone to verify the sensor triggers correctly and adjust the sensor angle if needed.

Tip: Avoid mounting the motion sensor facing heat sources or busy roads, as these can cause false triggers.

ABS Housing Care: Wipe the exterior with a damp cloth and mild detergent periodically to remove dirt, pollen, and cobwebs. Rinse with clean water and dry. The IP66 rating means the housing can handle water contact.

LED Lens Cleaning: Clean the light lens with a soft cloth to remove grime buildup that can reduce light output. Avoid abrasive pads that could scratch the lens.

Motion Sensor Maintenance: Keep the PIR sensor window clean and free of obstructions such as spider webs, leaves, or dirt. A blocked sensor will reduce detection range and reliability.

Seal Inspection: Check the rubber gaskets and mounting seals annually, especially after extreme weather. Replace any cracked or deteriorated seals to maintain waterproof protection.

Electrical Safety: Always disconnect power before cleaning or inspecting. If the light shows signs of moisture inside the lens, turn off power immediately and inspect the seals.